Table of Contents
Advertisement
CONCERN
Header/straw elevator (A),
threshing mechanism (C)
or unloading system (B)
not engaging.
No lateral float control (E).
No reversing mechanism
control (F).
(*) NOTE:
It is always possible to control the hydraulic valves manually by pushing the electrical spool (rubber cap) of the valve con-
cerned.
POSSIBLE CAUSE
No hydraulic control (can be
checked
when
normally
pushing on the electrical
spool).
No current to spool.
No hydraulic control.
No current to spool.
No hydraulic control.
CORRECTION
Check oil level and top up, if
needed.
Check and tighten pump
drive belt.
Check if valve D, which deliv-
ers the oil pressure to the en-
gaging valves A, B and C, op-
erates now and then (audi-
ble).
If necessary, operate lateral
float control/reversing mech-
anism, reel vertical or hori-
zontal control, to have high
pressure so that the engaging
valves A, B or C can operate.
Contact your local dealer.
Check and replace fuse, if
needed.
Use plug of reel horizontal
control valve (J) and the ped-
als to control the system. (*)
Check oil level and pump
drive.
Contact your local dealer.
Check fuse and replace, if
needed.
Contact your local dealer.
Check oil level and top up, if
needed.
Check and tighten pump
drive belt.
Contact your local dealer.
SECTION 6
PAGE
3-19
5--19
Fig. 1
--
5-57
Fig. 2
3-19
5-19
--
5-57
--
3-19
5-19
--
6-15
Advertisement
Table of Contents
