Table of Contents
Advertisement
FIELD OPERATION
With the rpm mode selected, the following information
will be provided:
3.1
Engine load bargraph A -- Figure 89
The bargraph segments light up proportionally to the
measured engine speed. All segments light up with
the engine at maximum speed (without load).
Maximum engine speed minus 5%:
Engine bargraph lower segment and symbol R start to
blink.
Maximum engine speed minus 10%:
Engine symbol R blinks and bargraph is empty.
Performance bargraph B -- Figure 90
3.2
Two bargraphs are provided for displaying the sieves
S and straw walker T losses.
The bargraph segments light up proportionally to the
losses and to the potentiometer X setting (sensitivity).
The potentiometer setting is displayed from 1 to 10
above the bargraphs: the higher the number, the high-
er the sensitivity.
To set the combine performance monitor, proceed as
follows:
1. Engage the threshing and the header drive.
2. Engage the first or second gear and enter the
crop.
3. Adjust the reel height, the reel fore and aft setting
and the reel speed, according to the type of crop
being harvested.
4-54
89
90
54770
54771
Advertisement
Table of Contents
