Threshing On And Set Min Stubble; Execute Us Calibration And Enter When Done - New Holland TX62 Operator's Manual

FIELD OPERATION
m) Figure 146 - Appearing:

''THRESHING ON AND SET MIN STUBBLE

HEIGHT AND PUSH ENTER''
Bring the header in the minimum stubble
height position with switch 18 (Fig.1).
Press
n) Figure 147 - Appearing:
''EXECUTE US CALIBRATION AND ENTER
WHEN DONE''
Refer to paragraph headed ''Calibration of
the ground level through autofloat sensors''
at the beginning of this Section.
NOTE:
Even if your combine is not fitted with the
autofloat sensor device, it is necessary
to perform this calibration.
Press
4-96
to validate.
to validate.
146
147
48184
48185