Table of Contents
Advertisement
24 February, 1999
6.9.11 PRESSURE ROLLER AND PRESSURE ROLLER FUSING
LAMP
[D]
[B]
[A]
1. Disassemble the fusing unit into two parts (See Fusing Unit Disassembly,
Section 6.9.6).
2. Remove the oil tank [A].
3. Remove the oil supply unit assembly [B] (3 screws).
4. Remove the entrance guide plate [C] (2 screws).
5. Remove the front lamp holder [D] (1 screw).
6. Remove the front and rear connectors [E].
7. Disconnect the rear connector [E] while keeping the other connectors in place
(2 screws).
8. Slide the rear connector under the stay as shown [F].
9. Remove the pressure roller together with the pressure roller lamp [G].
10. Remove and replace the pressure roller lamp.
11. Replace the pressure roller and pressure roller bearings [H].
NOTE: The pressure roller fusing lamp is a 400 W lamp. The rating is printed on
one end of the lamp.
PAPER TRANSPORT, FUSING, AND PAPER EXIT SECTIONS
A259R553.WMF
[E]
6-73
[C]
[H]
[G]
[E]
[F]
[E]
A259R510.WMF
Advertisement
Table of Contents
