Table of Contents
Advertisement
24 February, 1999
6.11.3 NV-RAM UPLOADING AND DOWNLOADING
With SP mode, copier settings can be uploaded to a Flash ROM card from the NV-
RAM inside the machine, or downloaded from a Flash ROM card to the NV-RAM.
The Flash ROM card must contain the main program.
SP5-824: Upload
Executing an upload saves the copier settings (including the main counter value
and serial number) onto a Flash ROM card.
SP5-825: Download
Executing a download loads copier settings (excluding the main counter value and
serial number) from a Flash ROM card into the NV-RAM inside the copier.
Upload/Download Procedure
1. Print out the copier settings that have been modified from their defaults, using
SP7-902.
2. Turn the main power switch off and insert the Flash ROM card into the main
control board (see Main Program Downloading).
3. Turn the main power switch on and start one of the following SP modes.
• Upload: SP5-824
• Download: SP5-825
4. To start uploading or downloading:
A258: Input "1".
A259/A260: Press "OK".
5. Wait until end of processing is indicated on the screen (approximately 1 to 3
minutes, depending on the size of the software).
6. When an end of processing message appears, turn the main power switch off
and remove the Flash ROM card.
7. Replace all covers and turn on the main power switch.
8. Using the settings list printed in step 1 using SP7-902, input the values that
were different from the factory settings (after downloading).
SYSTEM AND ELECTRONICS
6-83
Advertisement
Table of Contents
