SCANNER UNIT
6.3.4 SCANNER WIRE/SCANNER MOTOR REPLACEMENT
[B]
[C]
[F]
1. Remove the exposure glass and the exterior covers.
2. Remove the upper right stay [A] (4 screws) and the upper left stay [B] (4
screws).
3. To change the front scanner wire: Remove the wire cover [C] (2 screws).
To change the rear scanner wire: Do the following.
a) Disconnect the platen cover position sensor [D] and remove the platen
cover frame [E] (4 screws).
b) Remove the lamp regulator [F] (2 screws) and scanner drive board [G] (4
screws).
[A]
A259R011.WMF
[E]
[G]
A259R009.WMF
6-22
24 February, 1999
[D]
A259R008.WMF