Table of Contents
Advertisement
24 February, 1999
Side-to-side Registration
Standard value: 2 ± 2 mm
1. Enter SP mode 1-2 (side-to-side registration adjustment).
2. Select the paper feed unit to test.
• Manual feed (by-pass feed table)
• Tray 1 (Copier paper feed tray): A258 only
• Tray 2 (Optional paper feed unit, first tray)
• Tray 3 (Optional paper feed unit, second tray)
• Tray 4 (Optional paper feed unit, third tray)
• Duplex 2
nd
NOTE: Any value entered for Tray 1 is ignored in duplex models.
3. Type a number in "Data Input" on the screen at the ten-key pad.
Input value range: -5.0 to 5.0
After entering a number, press the # (Enter key) to save the number in "Set
Data."
To move the image to the right (when viewing towards the direction of paper
feed): Increase the stored value.
To move the image to the left (when viewing towards the direction of paper
feed): Decrease the stored value.
NOTE: To enter a negative number, press the ó key before typing the value
of the negative number.
4. Repeat step 3) until the distance [B] in the trim pattern (see the previous page)
falls within the specified range.
NOTE: After the registration adjustment, reset the value of SP5-955-18 to "0" to
resume normal copy operation.
PAPER FEED AND REGISTRATION SECTION
side (Duplex unit): A259/A260 only
6-63
Advertisement
Table of Contents
