Table of Contents
Advertisement
PAPER FEED AND REGISTRATION SECTION
24 February, 1999
6.8 PAPER FEED AND REGISTRATION SECTION
6.8.1 BY-PASS FEED TABLE REMOVAL
[B]
[A]
[C]
A259R701.WMF
1. Remove the right cover (see "Covers, Fans, and Filters").
2. Disconnect the connector [A].
3. Remove the front snap ring [B].
4. Tilt the by-pass feed table [C] by about 20 degrees, then remove it by pushing it
toward the rear.
6.8.2 BY-PASS PAPER WIDTH DETECTION BOARD
REPLACEMENT
[C]
[B]
[A]
A259R702.WMF
1. Remove the by-pass feed table.
2. Remove the by-pass feed cover [A] (2 screws).
3. Remove the by-pass feed paper width detection board [B] (1 screw).
NOTE: When installing the board, take care not to bend the terminal plate [C].
6-56
Advertisement
Table of Contents
