1242 [Fusing Pressure Roller On Before Fusing]; 1243 [Fusing Pressure Roller On After Fusing] - Ricoh Pro C9200 Operating Instructions Manual

4. Details of Menu Items in Advanced Settings
Setting Item
05: Corct Temp: Initial Feed
06: Corct Temp: Pre-Feed
[Initial Sheet Interval]
Adjust the sheet interval by reducing the print speed.
• If the value in this setting is changed, the throughput is reduced because of the increased interval
between printing each sheet immediately after printing starts.
Setting Item
07: Low Temperature: 1 Sided/08: 1
Sided/09: Low Temperature: 2 Sided/10:
2 Sided

1242 [Fusing Pressure Roller On Before Fusing]

Set whether make pressure roller contact with the fusing belt or not before printing starts (before feed).
• If set to [1:On], the time taken for adjusting the fusing temperature at the start of printing becomes
longer.
01: Setting

1243 [Fusing Pressure Roller On After Fusing]

Set whether make pressure roller contact with the fusing belt or not after printing finishes (after feed).
• If set to [1:On], the time taken for adjusting the fusing temperature at the end of printing becomes
longer.
144
Setting Item
Max. Value Min. Value
30 0
50
Max. Value Min. Value
3 0
[0:Off]
[1:On]
Step Unit
1 deg
Step Unit
1 None
Values