Table of Contents
Advertisement
24 February, 1999
3.11 CONTROLLER INTERFACE TYPE E (A848)
[D]
[L]
[H]
[K]
[J]
ø
CAUTION
Unplug the copier power cord before starting the following procedure.
1. Remove the lower rear cover [A] (3 screws).
2. Remove the upper rear cover [B] (4 screws).
3. Remove the rear right cover [C] (1 screw).
4. Remove the right cover [D] (1 screw).
5. A259/A260 only: Remove the shield cover [L] (3 screws).
6. Attach the I/F bracket [E] to the right rear side of copier (1 screw, 1 screw with
washer [F]).
7. Attach the I/F unit [G] to the I/F bracket [H] (1 snap ring [I]).
NOTE: Route the power supply cord [K] to the rear side of copier (1 clamp [J]).
CONTROLLER INTERFACE TYPE E (A848)
[B]
[A]
A848I501.WMF
[C]
[I]
A848I503.WMF
3-55
[F]
[E]
A848I502.WMF
[G]
Advertisement
Table of Contents
