Table of Contents
Advertisement
24 February, 1999
3.1.2 ENVIRONMENTAL REQUIREMENTS
To ensure the optimum copy quality, the following environmental requirements
need to be observed. When installing this copier at the customer site, make sure
that the location meets the following requirements.
1. Avoid an area which is exposed to direct sunlight or is excessively illuminated
(the illumination should not exceed 2000 lux.).
2. Avoid areas that are too hot and humid or too cold and dry.
Standard temperature range: 10ºC to 32ºC
Standard humidity range: 15% to 80%
3. Avoid areas near fire or heat.
4. Avoid areas that are exposed to sudden temperature changes. This includes
areas where the machine will not be directly exposed to:
1) Cool air from an air conditioner
2) Heat from a heater.
5. Avoid a dusty area (maximum allowable amount of dust: 0.10 mg/m
6. Avoid a poorly-ventilated area (required minimum ventilation: 30 m
7. Do not place the machine where it will be exposed to corrosive gases.
8. Place the machine on a level floor (the inclination on any side should be no
more than 5 mm).
9. Do not place the machine where it may be subjected to strong vibrations.
10. Do not install the machine at any location over 2,000 m (6,500 feet) above sea
level.
11. If the machine is installed close to other electronic equipment, they may
interfere with each other. To avoid this problem:
1) Keep the machine as far away as possible from television sets or radios.
2) Reorient the receiving antenna of television sets and radios as needed.
3) Use a separate outlet for the machine.
INSTALLATION REQUIREMENTS
3-3
3
).
3
/hr/man
Advertisement
Table of Contents
