Table of Contents
Advertisement
24 February, 1999
PAPER TRAY UNIT (A832/A833)
TRAY HEATER (OPTION)
[B]
[A]
[D]
[D]
[C]
A833I501.WMF
A833I502.WMF
[E]
A833I503.WMF
1. Remove all the trays (A832: 2 trays, A833: 3 trays).
2. A832 only: Remove the lower front cover (2 screws).
3. Remove the rear cover (4 screws).
4. Install the heater [A] (3 screws and 1 clamp [B]).
NOTE: The heater should be installed at the right side on the frame.
5. Install the radiator plate [C] (1 screw).
6. Install the 9 clamps [D] as shown.
7. Connect the cable [E] to the heater and the copier (9 clamps and 2 screws).
NOTE: After replacing the paper tray, adjust the side-to-side registration (see
Replacement and Adjustment – Paper Feed and Registration).
3-27
Advertisement
Table of Contents
