Connecting The Power Supply For Emulator - Renesas M34286T2-CPE User Manual

M34286T2-CPE User's Manual

2.6 Connecting the Power Supply for Emulator

Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the
emulator is listed in Table 2.3.
Figures 2.12 and 2.13 show the specifications of the power connector (J1) and an applicable plug, respectively.
Table 2.3 Specification of power supply of the emulator
Power supply voltage DC 5.0 V±5％/2 A
Figure 2.12 Specification of the power connector
Notes on Connecting a Power Supply of the Emulator:
• The power cable included in this product package is colored red (+) and black (-).
• Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy
internal circuits.
• Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause
burn injuries and the failure of internal circuits.
R20UT0214EJ0200 Rev.2.00
Sep 16, 2010
φ 1.7mm(Inside diameter)
Figure 2.13 Specification of an applicable plug
CAUTION
2. Setup
φ 4.75mm
Page 30 of 70