Renesas M34286T2-CPE User Manual page 40

M34286T2-CPE User's Manual
(2) Setting the Init dialog box (2/2)
By pressing [OK] after setting the Init dialog box (1/2), the following Init dialog box will be displayed.
Note on selecting the system clock :
• When selecting System Clock in the INIT dialog, be sure to select the same system clock as those to be
specified in the user program.
If the system clock you select is different from the setting on the user system, the emulator will not
work properly. When the emulator does not work properly, quit the emulator debugger. Then, before
restarting the emulator debugger, be sure to turn off the power of the emulator and turn it on again.
R20UT0214EJ0200 Rev.2.00
Sep 16, 2010
3. Usage (How to Use the Emulator Debugger)
Selecting the target MCU
Select the target MCU that you are going to
debug.
Selecting the System Clock
Select the system clock that you are going to set
within the user program.
Default:
CCK or Default : System clock will be changed from
CCK2 or Default: System clock will be changed from
CCK4 or Default: System clock will be changed from
IMPORTANT
System clock is used at f(XIN)/8.
f(XIN)/8 to f(XIN)/1 by the CCK
instruction.
f(XIN)/8 to f(XIN)/2 by the CCK2
instruction.
f(XIN)/8 to f(XIN)/4 by the CCK4
instruction.
Page 40 of 70