Notes On Using This Product - Renesas M34286T2-CPE User Manual

M34286T2-CPE User's Manual

4.5 Notes on Using This Product

Notes on using this product are listed below. When debugging the MCU using this product, be careful about the
following precautions.
Notes on the Self-check:
• If the self-check does not result normally (excluding target status errors), the emulator may be damaged.
Then contact your local distributor.
• Run the self-check with the user system not connected.
Note on Quitting the Emulator Debugger:
• To restart the emulator debugger, always shut power to the emulator module off once and then on again.
Notes on the User System (Power Supply, Order of Powering On):
• This emulator cannot supply the power to the user system. Therefore design your system so that the user
system is powered separately.
• The voltage of the user system should be as follows.
3.0 V±5%
• Do not change the voltage of the user system after turning on the power.
• Before powering on your emulator system, check that the host machine, the emulator, the converter
board and user system are all connected correctly. Next, turn on the power to each equipment following
the procedure below.
(1) Turn ON/OFF the user system and the emulator as simultaneously as possible.
(2) When the emulator debugger starts up, check the target status LEDs on the emulator to see if this
product is ready to operate.
Is the power supplied?
Is the clock supplied?
*1 When the user system is not connected, the target status LED (POWER) is not lit.
R20UT0214EJ0200 Rev.2.00
Sep 16, 2010
IMPORTANT
Check that target status LED (POWER) is ON.*1
Check that target status LED (CLOCK) is ON.
4. Hardware Specifications
Page 59 of 70