Verizon CR1000A User Manual page 56

BaSiC SEttingS
2. Enable the protected setup by moving the selector to on
3. Use one of the following methods:
• If your Wi-Fi client device has a WPS button, press the
WPS button on your router for more than two seconds,
then click the start WPS
the WPS registration process.
• If your client device has a WPS PIN, locate the
PIN printed on the client's label or in the client
documentation. Enter the PIN number in the Enter PIN
field. The Client WPS PIN
on the user interface.
• Click Register
• Alternatively, you can enter the router's PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
4. After pressing the WPS button on your router, you have two
minutes to press the WPS button on the client device before
the WPS session times out.
When the WPS button on your router is pressed, the Router
Status LED on the front of your router begins flashing blue.
The flashing continues until WPS pairing to the client device
completes successfully. At this time, the Router Status LED
turns solid blue.
If WPS fails to establish a connection to a Wi-Fi client
device within two minutes, the Router Status LED on your
start WPS button in the Option 1
Client WPS PIN field is located within Option 2
Register.
on.
Option 1 to start
Enter PIN
Option 2