Dhcpv6 Pd - Wan Ipv6 Address Connection - Verizon CR1000A User Manual

nEtWoRk SEttingS
2. Specify the settings to be used to assign LAN IPv6
addresses by entering the following details:
• IPv6 LAN Configuration IPv6 LAN Configuration (select Stateless from the
dropdown list)
• LAN Prefix (automatically populated) LAN Prefix
• IPv6 LAN Address (automatically populated) IPv6 LAN Address
• LAN Link Local Address (automatically populated) LAN Link Local Address
• Subnet ID - set the site topology for your internal site Subnet ID
• Router Advertisement Lifetime (minutes between 0-150) Router Advertisement Lifetime
• Option: Allow ICMPv6 Echo Request for LAN devices Option: Allow ICMPv6 Echo Request for LAN devices
using their Global IPv6 Address from WAN side - using their Global IPv6 Address from WAN side
requesting an IPv6 address from any available DHCPv6
servers available on the ISP
3. After entering all appropriate IPv6 settings, click Apply
changes changes to have changes take effect.

DHCPv6 PD - WaN IPv6 address Connection

The IPv6 WAN DHCPv6 configurations are IPv6 settings that you
enter that will allow your IPv6 connection to be updated by the ISP
as needed.
1. To configure IPv6 WAN Stateful (DHCPv6) mode, select the
DHCPv6-PD DHCPv6-PD option on the IPv6 Configuration Control
as shown below:
IPv6 Configuration Control page
Apply