Verizon CR1000A User Manual page 118

If DHCP Server is enabled on your Verizon Router, configure the
network devices as DHCP Clients. There are 2 basic options in this
section: Disabled Disabled and DHCP Server
To set up the Verizon Router's network bridge to function as a
DHCP server:
1. In the IP Address Distribution IP Address Distribution section, select the DHCP
server server. Once enabled, the DHCP server provides automatic
IP assignments (also referred to as IP leases) based on the
preset IP range defined below.
• Start IP Address – Enter the first IP address in the IP Start IP Address
range that the Verizon Router will automatically begin
assigning IP addresses from. Since your Verizon Router's
IP address is 192.168.1.1, the default Start IP Address is
192.168.1.2.
• End IP Address – Enter the last IP address in the IP range End IP Address
that the Verizon Router will automatically stop the IP
address allocation at. The maximum end IP address range
that can be entered is 192.168.1.254.
2. If Windows Internet Naming Service (WINS) is being used,
enter the WINS Server
3. In the Lease Time in Minutes Lease Time in Minutes field, enter the amount of time
a network device is allowed to connect to the Verizon Router
with its currently issued dynamic IP address.
DHCP Server.
WINS Server address.
06 / CONFIGURING
ADVANCED SETTINGS
DHCP
©2021 Verizon. All Rights Reserved
118