Preparing To Use The Sprayer - Toro Multi Pro 5800-D Operator's Manual

Filling the Fuel Tank
Fuel tank capacity: approximately 45 L (12 US
gallons).
1. Park the machine on a level surface, engage
the parking brake, shut off the spray pump, shut
off the engine, remove the key, and allow the
engine to cool.
2. Clean the area around the fuel-tank cap
20).
Figure 20
1. Fuel-tank cap
3. Remove the fuel-tank cap.
4. Fill the tank to about 2.5 cm (1 inch) below the
top of the tank (bottom of the filler neck).
Note:
This air space in the tank allows fuel to
expand. Do not overfill the tank.
5. Install the fuel-tank cap to the tank securely.
6. Wipe up any fuel that may have spilled.
Preparing to Use the
Sprayer
Cleaning the Suction Filter
Service Interval: Before each use or daily—Clean the
(Figure
1. Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
2. At the top of the sprayer tank, remove the
retainer that secures the hose fitting attached to
the large hose from the filter housing
g194161
1. Suction hose
3. Remove the hose and hose fitting from the filter
housing
4. Pull the suction strainer out of the filter housing
in the tank
1. Screen vane
5. Clean the suction filter with clean water.
Important:
or cannot be cleaned.
27
suction filter. Clean the suction filter
(more often when using wettable
powders).
Figure 21
2. Retainer
(Figure 21).
(Figure 22).
Figure 22
2. Suction strainer
Replace the filter if it is damaged
(Figure 21).
g033577
g033578