Toro Multi Pro 5800-D Operator's Manual page 56

1. Oil-filler cap
4. Install the oil-filler cap.
5. Install the dipstick firmly in place.
Changing the Engine Oil Filter
1. Remove the forward heat shield; refer to
Removing the Forward Heat Shield (page
2. Raise the seats.
CAUTION
Components under the seat will be hot
if the sprayer has been running. If you
touch hot components, you may be
burned.
Allow the sprayer to cool before
performing maintenance or touching
components under the hood.
3. Align a drain pan under the engine oil filter
(Figure 71).
1. Drain plug
4. Remove the old oil filter
Note:
Dispose of the used oil filter at a certified
recycling center.
Figure 70
Figure 71
2. Engine oil filter
(Figure 71).
5. Wipe clean the surface of the oil filter adapter of
the engine with a rag.
6. Fill the oil filter with the specified oil.
Note:
oil.
7. Apply a thin coat of the specified oil to the rubber
gasket on the replacement oil filter.
8. Install the oil filter to the filter adapter and turn
the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter
g028155
an additional 1/2 turn
Note:
9. Wipe clean any residual oil.
Changing the Engine Oil
1. Align a drain pan under the drain plug
71).
2. Remove the drain plug and allow the oil to drain
completely
48).
Note:
and damage; replace the seal if it is worn or
damaged.
Note:
recycling center.
3. Install the drain plug into the drain port of the
engine-oil pan and tighten the plug to 33 to 37
N∙m (24 to 27 ft-lb).
4. Tilt the passenger seat forward and align the
prop rod into the detent in the prop-rod-guide
slot.
5. Remove the oil-filler cap from the filler neck of
the valve cover of the engine and slowly pour
approximately 80% of the specified amount of oil
into the filler neck
g028169
1. Oil-filler cap
56
Allow the filter element to saturate with
(Figure
Do not overtighten the oil filter.
(Figure 71).
Check the drain-plug seal for wear
Dispose of the used oil at a certified
(Figure 72).
Figure 72
71).
(Figure
g028155