Toro Multi Pro 5800-D Operator's Manual page 70

Changing the Hydraulic Fluid
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Hydraulic-fluid capacity: 56 L (15 US gallons) of
the specified hydraulic fluid or equivalent; refer to
Checking the Hydraulic Fluid (page
Important:
Using any other fluid may void the
warranty on some components.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic fluid to cool before
performing any maintenance to the hydraulic
system.
1. Replace the hydraulic-fluid filters; refer to
Replacing the Hydraulic-Fluid Filters (page
2. Clean the area around a hydraulic-hose fitting on
the bottom of the hydraulic-fluid tank
Figure 94
1. Hydraulic tank
3. Place a large drain pan under the hydraulic tank
fittings.
4. Remove the hose fitting from the tank, allowing
the fluid to drain into the pan
5. Install the hose and fitting to the tank and tighten
it securely.
6. Fill the hydraulic reservoir with approximately 53
L (14 US gallons) of specified hydraulic fluid or
equivalent; refer to
(page 68).
7. Start the engine, set the throttle at fast idle, and
let the engine run 3 to 5 minutes to purge air
from the hydraulic system.
68).
(Figure
2. Hydraulic hose and fitting
(Figure 94).
Checking the Hydraulic Fluid
8. Shut off the engine, check the hydraulic-fluid
level, and check for leaks.
9. Dispose of the used fluid at a certified recycling
center.
69).
94).
g014219
70