Toro Multi Pro 5800-D Operator's Manual page 50
Hide thumbs
Also See for Multi Pro 5800-D:
- Operator's manual (96 pages) ,
- Installation instructions manual (64 pages) ,
- Software manual (36 pages)
Table of Contents
Advertisement
Figure 59
1. Engine mount
2. Bolt—shown for clarity; do
not remove
3. Mounting tabs
(undercarriage shroud)
3.
Move the mounting tabs off the bolts that secure
the undercarriage shroud to the engine-mount
brackets.
4.
Remove the undercarriage shroud from the
machine
(Figure 58
Installing the Undercarriage
Shroud
1.
Align the undercarriage shroud to the bottom
chassis of the machine; refer to
Removing the Undercarriage Shroud (page
2.
Move the mounting tabs of the undercarriage
shroud over the bolts and carriage bolt at the
engine-mount brackets of the machine; refer
to
Figure 59
in
Removing the Undercarriage
Shroud (page
49).
3.
Assemble the undercarriage shroud to the
engine-mount brackets and bolts
59) with the 4 flange locknuts (5/16 inch)
that you removed in step
Undercarriage Shroud (page
4.
Align the holes in the rear part of the
undercarriage shroud with the holes in the
chassis; refer to
Undercarriage Shroud (page
5.
Assemble the rear part of the undercarriage
shroud to the chassis
5 flange-head bolts (5/16 x 7/8 inch) and 5
washers (5/16 inch) that you removed in step
of
Removing the Undercarriage Shroud (page
49).
6.
Torque the nuts and bolts to 1129 to 1582 N∙cm
(100 to 140 in-lb).
4. Flange locknuts (5/16
inch)
5. Front of the machine
and
Figure
59).
Figure 59
(Figure
2
of
Removing the
49).
Figure 58
in
Removing the
49).
(Figure
58) with the
Removing the Seat-Base-Access
Panel
1.
Remove the 2 flanged-head bolts that secure
the seat-base-access panel to the seat base
(Figure
60).
g189583
1. Seat-base-access panel
2. Flanged-head bolt
in
2.
Remove the seat-base-access panel from the
49).
machine
Installing the Seat-Base-Access
Panel
1.
Align the holes in the seat-base-access panel
with the holes in the seat base
2.
Assemble the seat-base-access panel to the
seat base with the 2 flanged-head bolts
60) that you removed in step
Seat-Base-Access Panel (page
3.
Torque the bolts to 1975 to 2542 N∙cm (175 to
225 in-lb).
1
50
Figure 60
3. Hole (seat base)
(Figure
60).
(Figure
1
of
g032998
60).
(Figure
Removing the
50).
Advertisement
Table of Contents
