Toro Multi Pro 5800-D Operator's Manual page 46

Maintenance Service
Maintenance Procedure
Interval
• Grease the actuator-rod bearings.
• Complete all yearly maintenance procedures specified in the engine owner's manual.
• Check the fuel lines and connections.
• Replace the fuel-filter canister.
• Replace the in-tank fuel filter.
• Drain and clean the fuel tank.
• Pack the front wheel bearings.
• Change the planetary-gearbox fluid.
• Check the coolant (as directed by the manufacturer) and change if necessary.
Every 400 hours
• Replace the hydraulic-fluid filters.
• Change the hydraulic fluid.
• Inspect the O-rings in the valve assemblies and replace them if necessary.
• Change the suction filter.
• Change the pressure filter.
• Inspect the nylon pivot bushings.
• Inspect the pump diaphragm and replace if necessary
• Inspect the pump check valves and replace if necessary
• Flush the sprayer with clean water.
Yearly
• Calibrate the agitation-bypass valve.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
46