Toro Multi Pro 5800-D Operator's Manual page 34

Note:
Use the master section switch to start
and stop the flow of chemical s to the selected
spray sections.
11. When finished spraying, set the master section
switch to the O
FF
sections, then set the spray-pump switch to the
O position.
FF
Note:
Raise the outer spray sections to the
transport position and drive the sprayer to the
cleaning area.
Important:
Always raise the boom sections
until they have moved completely into
section-transport cradle forming the "X"
transport position and the lift cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Spraying in the Manual Mode
Note:
This procedure assumes that the spray pump
is on; refer to Figure 31
Rate Mode (page 32).
1. Ensure that the sprayer system is adjusted for
the active spray nozzles that you have selected;
refer to Setting the Section-Bypass Valves (page
38).
2. Set the sprayer mode button to the Manual
Mode (Figure 32).
1. Manual mode position
3. Set the master section switch to the O
position; refer to
Application Rate Mode (page
4. Adjust the throttle to the desired engine speed
to spray; refer to
Application Rate Mode (page
5. Drive to the spraying location.
6. Lower the sections into position.
position to turn off all spray
in Spraying in the Application
Figure 32
2. Sprayer-mode switch
Figure 30 in Spraying in the
32).
Figure 31 in Spraying in the
32).
7. Set the individual section switches, as needed,
to the O
in the Application Rate Mode (page
8. Use the application-rate switch to achieve the
desired spray pressure as indicated in the
nozzle-selection guide provided with the sprayer
(Figure
1. Application-rate switch
9. Drive at the desired speed and then set the
master section switch to the O
spraying; refer to
Application Rate Mode (page
Note:
agitation may cause foaming in the tank. In
this case, turn the agitation switch to the O
position. Alternatively, you can add anti-foaming
agent to the tank.
10. When you are finished spraying, set the master
section switch to the O
sections, then set the spray-pump switch to the
O
FF
Note:
position and drive the sprayer to the cleaning
area.
Important:
g192608
until they have moved completely into
section-transport cradle forming the "X"
transport position and the section cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
FF
move to a storage or cleaning area.
34
position; refer to
N
33).
Figure 33
Figure 30
When the tank is nearly empty, the
position to turn off all
FF
position.
Return the sections to the transport
Always raise the sections
Figure 30 in Spraying
32).
g193782
position to begin
N
in Spraying in the
32).
FF