Toro Multi Pro 5800-D Operator's Manual page 49
Hide thumbs
Also See for Multi Pro 5800-D:
- Operator's manual (96 pages) ,
- Installation instructions manual (64 pages) ,
- Software manual (36 pages)
Table of Contents
Advertisement
Installing the Forward Heat Shield
1.
Align the rear flange of the forward heat shield
over the forward flange of the rear heat shield
(Figure
57).
Figure 57
1. Front of the machine
2. Hex-head bolts and
washers
2.
Align the holes in the forward heat shield with
the threaded holes in the chassis
3.
Assemble the forward heat shield to the machine
with the 6 hex-head bolts and 6 washers
57) that you removed in step
Forward Heat Shield (page
4.
Torque the bolts to 1978 to 2542 N∙cm (175 to
115 in-lb).
5.
Remove the jack stands and lower the machine.
Removing the Undercarriage
Shroud
1.
Remove the 5 flange-head bolts (5/16 x 7/8
inch) and 5 washers (5/16 inch) that secure the
rear of the undercarriage shroud to the chassis
of the machine
(Figure
Note:
Retain the flange-head bolts and
washers for installation in step
Undercarriage Shroud (page
g028177
3. Rear flange (forward heat
shield)
4. Forward flange (rear heat
shield)
(Figure
57).
(Figure
3
of
Removing the
48).
58).
5
of
Installing the
50).
1. Flange-head bolts (5/16 x
7/8 inch)
2. Undercarriage shroud
2.
Remove the 4 flange locknuts (5/16 inch) from
the bolts and carriage bolt that secure the
mounting tabs of the undercarriage shroud
to the engine-mount brackets of the machine
(Figure
59).
Note:
Do not remove the bolts from
the machine. Retain the flange locknuts
for installation in step
Undercarriage Shroud (page
49
Figure 58
3. Washers (5/16 inch)
4. Front of the machine
3
of
Installing the
50).
g189584
g189585
Advertisement
Table of Contents
