Adjusting The Front Wheel Toe-In - Toro Multi Pro 5800-D Operator's Manual

Adjusting the Front Wheel
Toe-in
Service Interval: Every 200 hours/Yearly (whichever
comes first)
You should measure 0 to 3 mm (0 to 1/8 inch) between
the front centerline of the tires and the back centerline
of the tires.
1. Check and fill all tires; refer to
Air Pressure (page
2. Measure the distance between both of the front
tires at the axle height at both the front and rear
of the front tires (Figure
Note:
The distance between the front of the
tires should be 0 to 3 mm (0 to 1/8 inch) less
than the distance between the back side of the
front tires.
Figure 84
1. Tire center line—back
2. Tire center line—front
3. If the measurement does not fall within the
specified range, loosen the jam nuts at both
ends of the tie rod
Figure 85
1. Jam nut
Checking the Tire
26).
84).
3. Axle center line
(Figure 85).
2. Tie rod
4. Rotate the tie rod to move the front of the tire
inward or outward.
5. Tighten the tie rod jam nuts when the adjustment
is correct.
6. Ensure that the steering wheel rotates an equal
amount in both directions.
g002247
g002248
64