Serial Connections - GCC Technologies Elite 12/1200N Installation Manual

L T
OCAL ALK CONNECTION (E
The LocalTalk cable system connects to AppleTalk-compatible networks. This connection
forms a chain; do not connect devices so that it forms a circle.
Important: You need a connector kit for each device on the network. Therefore, you need
two connector kits to connect the printer to one computer, and so forth.
To plug in LocalTalk cables:
Connector box
Terminator
S
ERIAL CONNECTIONS (E
See Elite 12ppm users manual
16 16
12/600 E
LITE AND LITE
Resistor
Cable
12/600 E 1212 O
LITE AND LITE
1212)
1. Switch off the printer.
2. Connect one LocalTalk connector box to the
LocalTalk port on the printer.
3. Connect one LocalTalk connector box to the
printer port (identified by a printer icon) on
the back of the Macintosh.
4. Connect the LocalTalk boxes together with
one of the LocalTalk cables. You will only
need one LocalTalk cable (for one Macintosh
and one printer).
5. You may need to install terminator resistors
that were included in your kit.
6. Switch on the printer.
7. Verify the printer's LocalTalk setting. The 8-pin
serial submenu, accessed from the printer's
control panel, should be set to LocalTalk.
LocalTalk is the factory default, so you should
not need to change the setting.
)
NLY