2.4
Cable Connections
Puma III communicates with a computer through USB (Universal Serial Bus),
or Serial port (RS-232C). This chapter shows you how to connect the cutting
plotter to a host computer and how to set up the computer/cutting plotter
interconnection.
!!
Notice:
When USB connection is enabled, serial port will be disabled
automatically.
Figure 2-18
2.4.1 USB Interface
Puma III build-in USB interface is based on the Universal Serial Bus
Specifications Revision 1.1. USB is not available in Windows 95, Windows NT.
USB driver installation
Caution!!
If you are using Windows 8/ 7/ Vista/ XP/ 2000 as your
operating system, make sure you log in using the
"Administrator" account.
Installation
Puma III User Manual
Serial Interface Connector (RS232C)
used to connect the cutting plotter to a
computer through a serial interface cable.
USB Connector
used to connect the cutting plotter to a
computer through a USB cable.
2-9