Federal Communications Commission; Canadian Regulations - GCC Technologies Elite 12/1200N Installation Manual

FEDERAL COMMUNICATIONS COMMISSION

WARNING: This equipment was tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the instructions in this manual, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur in a particu-
lar installation. For more information about radio frequency interference, refer to the section of this manual on
Radio and TV interference.

CANADIAN REGULATIONS

This equipment is a Class B digital apparatus that complies with the Radio Interference Regulations, CRC c.
1374.
IMPORTANT:
Changes or modifications to this product not authorized by GCC Technologies Inc. could void
the FCC Certification and negate your authority to operate the product. This product was tested for FCC Com-
pliance under conditions that included the use of shielded cables and connectors between system compo-
nents. It is important that you use shielded cables and connectors to reduce the possibility of causing interfer-
ence to radios, television sets, and other electronic devices. You can obtain the proper shielded cables from
GCC Technologies or from an Authorized GCC Technologies dealer.
CLASS 1 LASER PRODUCT
LASER SAFETY: This printer is certified as a Class 1 laser product under the U.S. Department of Health and
Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and
Safety Act of 1968. This means that the printer does not emit hazardous radiation. Since radiation emitted
inside the printer is completely confined within protective housings and external covers, the laser beam can-
not escape from the machine during any phase of user operation. The Center for Devices and Radiological
Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products on August
1, 1976. These regulations apply to laser products marketed in the United States. The label on the printer indi-
cates compliance with the CDRH regulations and must be attached to the laser products marketed in the United
States.
Caution - Use of controls, adjustments, or performance of procedures other than
those specified in this manual may result in hazardous radiation exposure.
EPA ENERGY STAR COMPUTERS AWARD
The Elite 12 Series printer is designed to conserve electricity.
With its power-saving design, the Elite 12 Series qualifies for the
U.S. Environmental Protection Energy Star Computers Award.
CREDITS
© Copyright GCC Technologies Inc., 1999. All rights reserved.
The Elite 12 Series Installation Guide was written by David Field, Laurie Freitas, Wendi LeBlanc,
and Tom Linzey. It was edited by Donna Atwood, Kevin Curran, Lee Doron, Laurie Freitas, Wendi
LeBlanc, Tom Linzey, and David Nicholson. Illustrations by Bill Krech and Kathy Shackelford,
Cover design and layout by Adam DeFanti.
Fonts used in this documentation are from the Bitstream 45 collection that ships with the Elite 12 Series printer.
Installation Guide printed in USA. Part number 030.16463 Rev A.