Cable Connections; Usb Interface - GCC Technologies Jaguar IV Series User Manual

2.7 Cable Connection
The cutting plotter communicates with a computer through a USB (Universal Serial Bus) or a Serial
port (RS-232C). This chapter shows you how to connect the cutting plotter to a host computer and
how to set up the computer/cutting plotter interconnection.
!! Notice: When USB connection is enabled, serial port will be disabled automatically.
Figure 2-25

2.7.1 USB Interface

Jaguar IV build-in USB interface are based on the Universal Serial Bus Specifications
Revision 1.1. (Operation system of Windows 95, Windows NT don't support USB ).
USB driver installation
Caution!!
If you are using Windows 8/ 7/ Vista/ XP/ 2000 as your
operating system, make sure you log in using the
"Administrator" account.
Use the USB One-click Installation for quick driver installation. Follow the simple steps
below for driver setup.
Installation
Serial Interface Connector (RS232C) – used to
connect the cutting plotter to a computer
through a serial interface cable.
USB Connector
plotter to a computer through a USB cable.
2-15
Jaguar IV User Manual
used to connect the cutting
–