GCC Technologies Elite 12/1200N Installation Manual page 77

I
NSTALLING T H E
B
R A M
INTO T H E
C
B
A
A
E 1 2 S
LITE ERIES
1. Switch off the printer.
2. Unplug the interface cables from the back of
the printer. Do not unplug the power cord
from the AC outlet.
3. If necessary, move the printer so that you
have clear access to its left side.
4. Remove the paper tray.
5. Open the top cover by pressing the release
button on the top right of the printer.
6. You need to remove the side cover. Unscrew
the two thumbscrews at the rear of the printer
(A). If these are tight, you may need to use a
#2 Phillips screwdriver.
7. Reach inside the case. Pull the edge of the
cover (B) toward you, then move the cover
away from the rest of the printer to prevent it
from latching again.
75