GCC Technologies Elite 12/1200N Installation Manual page 27

I
NSTALLATION FOR
Before installing this software, be sure that the printer is connected to the Mac using an
appropriate cable and that both the printer and Mac are powered on. Also confirm that all
the steps in the Hardware Setup section of this manual have been followed.
These instructions show Mac OS 8.6. If you are using OS 8.5.1 or earlier, some instructions
are slightly different.
P C
RINTERS ONNECTED BY
A T
PPLE ALK (
1. Repeat Part One (steps 1-11 on pages 19-21)
- Installing the GCC driver software and fonts
for Printers Connected by USB.
2. For AppleTalk installation only:
• If you are using an Ethernet port on your
Macintosh to communicate to your
printer, open control panels on the
Macintosh and go to AppleTalk. Set the
AppleTalk connection to Ethernet. Close
the AppleTalk control panel. If prompted
to save your new configuration,
click Save.
• If you are using a LocalTalk port on your
Macintosh to communicate to your
printer, open control panels on the
Macintosh and go to AppleTalk. Set the
AppleTalk connection to Printer Port or
Modem Port, depending on which port
your LocalTalk network is connected to.
Close the AppleTalk control panel. If
prompted to save your new configuration,
click Save.
L T E
VIA OCAL ALK OR THERNET
)
25