Table of Contents
Advertisement
Chapter 3:
Configuration Overview
SC-ADT configuration is performed through the command line interface (CLI). You can execute
CLI commands at a HyperTerminal connection or through a Telnet connection. A brief overview
of CLI is provided below. For a detailed guide to Smart CLI, refer to
Guidelines
. The web-based CLI is described in
The SC-ADT command line interface is an interactive means of configuring the SC-ADT through
a Telnet session over the LAN or by typing commands at a VT100-compatible ACSII terminal
connected to the SC-ADT
provides general and context-sensitive help, automatically expands abbreviated command or
subcommands and also anticipates any required command arguments. The CLI will prompt for any
required argument that is missing from a command line.
Smart CLI Quick Reference
•
Get context-sensitive command help by using the ? character in the CLI command string.
•
Type ? at the command prompt to view a description of IP and Utility commands (shown
below). If you are in User mode, some commands shown below will not display.
ADT-16%> ?
______________________System Commands____________________________________
clear
configure
connect
default
disable
enable
help
ping
show
telnet
trace-rte
_______________________Utility Commands___________________________________
batch
chat
contact
diags
exit
find-alert Find port alert string by port
flash
reboot
netstat
services
syslog
who-am-i
•
Execute each command string by pressing the
•
Commands entered in the proper syntax and with all required parameters/arguments will take
effect immediately. If required parameters or arguments are missing from the command string,
you will be prompted for them individually.
•
Abbreviated commands are accepted at the command prompt.
•
To configure IP and subnet mask addresses, refer to
076R172-000
Issue 6
SC-ADT Configuration
port. The CLI is a smart, controlled-access interface that
CRAFT
Reset functions
Configure system parameters
Connect to terminal port or modem
Default configuration to factory values.
Turn off supervisor/admin commands
Turn on supervisor/admin commands
Description of the command line interface and help system
Send ping to remote device
Show system parameters
TELNET to remote device
Trace route packets take to remote device
Store and/or run commands in batch mode
Start/Answer chat session with another ADT CLI user
Turn contact on or off
Set/Show port loopback state
Exit Command Line Interface
Copy flash files/select flash boot file
Halt and perform a reboot
Show TCP socket connections
Show/Enable/Disable HTTP, SNMP, TELNET, SSH, TFTP & FTP Services
Send SYSLOG msg to server
Show current user nam
SpectraComm ADT
Installation and Operation Manual
Appendix A, Application
Chapter 4, The Web Interface
key (or <cr>).
Enter
Appendix A, Application Guidelines
.
.
3-1
Advertisement
Table of Contents
