Sc800 T3 Configuration Menu; Configuration Basics - General DataComm SpectraComm 800 T3 Installation & Operation Manual

Data service unit
Table of Contents

Advertisement

SC800 T3 Operation

SC800 T3 Configuration Menu

At the SC800 T3 Main Menu, press 1 and then press Enter to access the Configuration menu.
Table 3-3
describes the terminal interface selections.
Table 3-3
Configuration Screen Selections
Selection
Operational State
[1] Network Options
[2] DTE Options
[3] Alarm Configuration
[0] Return to Main Menu

Configuration Basics

The following procedure provides the basic steps for making configuration changes to the SC800
T3 DSU from any configuration screen. Each screen is described in detail following the procedure.
1. Type the selection number or letter of the configuration option you intend to change, and press
the Enter key. A cursor appears on the current setting field for the corresponding option.
2. Use the arrow keys to toggle the selected field through its potential settings.
3. When the field displays the desired setting, press the Enter key again. The cursor returns to
the Select field. Repeat steps 1 through 3 for each option you need to change.
4. After all required changes have been made, select 0 to exit the Configuration menu. The
following prompt will appear
Configuration Modifications have been Detected!
Save Changes:[N] Y=Yes N=No,
5. To save changes and update the DSU press the Y key, then press Enter. The new
configuration will go into effect immediately. If you decide not to put your changes into effect,
press the N key then press Enter to discard the changes and exit the Configuration menu.
6. The terminal interface returns to the SC800 T3 Main Menu.
Note
To configure the DSU for Master or Remote operation, you must set the hardware option switch on the card
accordingly. See Chapter 2 for details.
3-6
Read-only display of the operational state: Master or Remote
Advances to the Network Options screen
Advances to the DTE Options screen.
Advances to the Alarm Options screen.
Exits the Configuration menu; returns to SC800 T3 Main Menu.
SpectraComm 800 T3 Data Service Unit
Installation and Operation Manual
SC800 T3 Configuration Menu
Description
076R160-000
Issue 4

Advertisement

Table of Contents
loading

Table of Contents