Compliance - General DataComm SC-ADT 8 Port Installation & Operation Manual

Table of Contents

Advertisement

Preface

Compliance

FCC Part 68 (Drop-In Modem)
1.
This equipment complies with Part 68 of the Federal Communications Commission Rules.
On the outside surface of this equipment is a label that contains, among other information,
the FCC registration number. This information must be provided to the telephone company.
2.
The suitable USOC jack (Universal Service Order Code connecting arrangement) for this
equipment is shown below. If applicable, the facility interface codes (FIC) and service order
codes (SOC) are shown.
3.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This
equipment is designed to be connected to the telephone network or premises wiring using a
compatible modular jack that is Part 68 compliant.
4.
The ringer equivalence number (REN) is used to determine the number of devices that may
be connected to the telephone line. Excessive RENs on the telephone line may result in the
device not ringing in response to an incoming call. In most, but not all, areas the sum of the
RENs should not exceed 5.0. To be certain of the number of devices that may be connected
to the line, as determined by the total RENs, contact the local telephone company.
5.
If this equipment causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. But if advance
notice is not practical, the telephone company will notify you as soon as possible. Also, you
will be advised of your right to file a complaint with the FCC if you believe it is necessary.
6.
The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to make necessary modifications in
order to maintain uninterrupted service.
7.
If trouble is experienced with this equipment (the model of which is indicated below) please
contact GDC at the address shown below for details on how to make repairs. If the trouble is
causing harm to the telephone network, the telephone company may request you remove the
equipment from the network until the problem is resolved.
8.
No repairs are to be made by you. Repairs are to be made only through GDC or its licensees.
Unauthorized repairs void registration and warranty.
9.
This equipment should not be used on party lines or coin lines.
10.
If so required, this equipment is hearing aid compatible.
Model Number:
FCC Registration No:
Ringer Equivalence:
Modular Jack (USOC):
Service Center in USA:
076R172-000
Issue 6
MT5634SMI
AU7-USA-25814-M5-E
0.3B
RJ11C or RJ11W (single line)
General DataComm, Inc.
6 Rubber Avenue, Naugatuck, CT 06770
Telephone: 1-800 523-1713 or 1 203 729-0271
(Refer to page x in this document for additional contact information.)
SpectraComm ADT
Installation and Operation Manual
Compliance
vii

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-adt 16 portSc-adt 32 portSc-adt 16 por

Table of Contents