Table of Contents
Advertisement
The Web Interface
Starting A Web Session
This release of the SC-ADT provides the web-based Command Line Interface. To start a web
management session, enable the HTTP service, then type the IP address of a SC-ADT unit or type
the host name at any browser. The following login authorization screen appears:
User Name and Password
The SC-ADT web interface is protected by pre-configured user names, passwords and the
associated access privileges as assigned by an Administrator. A valid password can be up to 20
alphanumeric characters. If three consecutive invalid passwords are entered, a temporary lock-out
will occur.
Access Modes
Access modes configured by the Administrator determines whether a user name has Read-only or
Read-Write privileges to the SC-ADT web screens.
•
User Mode
(Read Only access)
•
Supervisor Mode
(Read/Write access permits data entry and configuration changes.)
•
Admin Mode - Access Denied
(Admin commands must be entered via Telnet or Craft interface.)
Note
Access will be denied to any user or supervisor if there are already eight web sessions in progress.
4-2
SpectraComm ADT
SpectraComm ADT
Username:
Password:
Supervisor password:
Login
SpectraComm ADT
Installation and Operation Manual
Introduction to Web Management
(optional)
076R172-000
Issue 6
Advertisement
Table of Contents
