Table of Contents
Advertisement
SC-ADT Configuration
Configuring CLI User Privileges
The following paragraphs describe the basic procedures for accessing and configuring SC-ADT
using the command line interface (CLI). Access to the SC-ADT is controlled by three CLI access
modes: USER, SUPERVISOR and ADMIN. The password-protected enable command sets the
access from user mode to supervisor or admin mode, depending on the password entered. The
command prompt suffix character identifies the mode you are currently in:
•
For USER mode, the prompt string ends in >
Commands in USER mode allow viewing but not changing configuration data.
•
For SUPERVISOR mode, the prompt string ends in #
Commands in SUPERVISOR mode allow USER access plus the ability to change
configuration data, reboot the unit, manipulate flash files and enable the TFTP server for file
downloads.
•
For ADMIN mode, the prompt string ends in %
Commands in ADMIN mode allow SUPERVISOR access plus the ability to set up and modify
user accounts for usernames and passwords. ADMIN mode also allows authentication for the
CRAFT port to be turned on or off.
Note
Some ADMIN mode configuration commands (i.e., enabling the craft port or setting up user accounts)
cannot be accessed or executed via the web-based CLI.
Note
Up to 20 usernames/passwords may be specified. The Default Username is
Password is
gdc
Note
Local authentication is conducted via usernames and passwords configured in the SC-ADT. You can also
configure SC-ADT for TACACS+ authentication which employs usernames and passwords residing on a
TACACS+ server. Refer to Chapter 5, undere the paragraphs on
Setting Up User Accounts
1. Type disable to turn off the supervisor access.
2. Turn Admin mode on by typing enable and entering the admin password. The command
prompt will now contain the % character.
3. Modify default admin and supervisor accounts by typing:
configure accounts add admin
configure accounts add supervisor
4. Add a user account and password by typing:
configure accounts add
Note
IMPORTANT! To ensure the security of your devices, you must change the supervisor and the admin
passwords from the factory defaults before proceeding with configuration or attaching any interfaces to the
network.
3-2
; Supervisor mode password is
[name] [password]
SpectraComm ADT
Installation and Operation Manual
Configuration Overview
gdc
supervisor
; Admin mode password is
TACACS+ Authentication Protocol
[new admin password]
[new suprv password]
; In User mode, the Default
admin
.
.
076R172-000
Issue 6
Advertisement
Table of Contents
