Table of Contents
Advertisement
Figure 74. Removing the left control panel
Next steps
Replace the left control
panel.
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the front
bezel.
4.
Remove the air
shroud.
Steps
1. Route the control panel cable through the side and the guide slots in the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the left control panel assembly in the slot on the system.
3. Connect the control panel cable to the system board connector.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 75. Installing the left control panel
Safety
instructions.
Before working inside your
system.
Installing and removing system components
79
Advertisement
Table of Contents
