Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Push the exhaust system far enough forward in direction of
-arrow- until the pretension on the retaining loop -1- at the ex‐
haust pipe is -a- = 6 to 10 mm.
– Position the front clamping sleeve (refer to
⇒ Fig. ""Front Clamping Sleeve - Installation Position"" , page
171
) and tighten the threaded connections evenly.
– Check the distance of left and right tail pipes to bumper:
•
Dimension -x- left = dimension -x- right.
Tightening Specifications
♦ Refer to
⇒ "1.1 Overview - Muffler", page 169
1.6
Exhaust System, Checking for Leaks
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 26 ; Exhaust Pipes/Mufflers; Exhaust System, Checking
for Leaks .
178
Rep. Gr.26 - Exhaust System, Emission Controls
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.