Audi A4 2015 Repair Manual page 42

Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
11 - Bolt
❑ 90 Nm + 90°
❑ Always replace after removing.
12 - Bolt
❑ 30 Nm
Support Bearing, Installation Position
♦ The raised section -2- of the engine support must engage into
the opening -1- on the support bearing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Overview - Manual Transmission Mount
1 - Nut
❑ Tightening specifica‐
tions. Refer to ⇒ Rep.
Gr. 34 ; Subframe
Mount; Overview - Sub‐
frame Mount .
❑ Only remove when the
transmission mount
must be separated from
the transmission sup‐
port
2 - Bolt
❑ Tightening specifica‐
tions. Refer to ⇒ Rep.
Gr. 34 ; Subframe
Mount; Overview - Sub‐
frame Mount .
3 - Tunnel Crossmember
❑ Removing and instal‐
ling. Refer to ⇒ Manual
Transmission; Rep. Gr.
34 ; Subframe Mount;
Overview - Subframe
Mount .
4 - Stop
❑ For the transmission
mount
5 - Transmission Mount
❑ Removing and instal‐
ling. Refer to
⇒ "2.4 Transmission
Mount, Removing and
Installing", page 41
6 - Bolt
❑ Tightening specifica‐
tions. Refer to ⇒ Rep. Gr. 34 ; Subframe Mount; Overview - Subframe Mount .
36
Rep. Gr.10 - Engine Assembly
.