Engine, Supporting In Installation Position; Engine Mount, Removing And Installing - Audi A4 2015 Repair Manual

Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
8 - Bolt
❑ Tightening specifications. Refer to ⇒ 7-Speed Dual Clutch Transmission; Rep. Gr. 34 ; Subframe Mount;
Overview - Subframe Mount .
9 - Bolt
❑ Tightening specifications. Refer to ⇒ 7-Speed Dual Clutch Transmission; Rep. Gr. 34 ; Subframe Mount;
Overview - Subframe Mount .
❑ Only remove when the transmission mount must be separated from the transmission support
10 - Nut
❑ Tightening specifications. Refer to ⇒ 7-Speed Dual Clutch Transmission; Rep. Gr. 34 ; Subframe Mount;
Overview - Subframe Mount .
❑ Only remove when the transmission mount must be separated from the transmission support
2.2 Engine, Supporting in Installation Posi‐
tion
Special tools and workshop equipment required
♦ Engine Support Bridge - 10-222A-
Procedure
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
– Position the -10-222A- as shown on the left and right fender
bolting edges.
– Engage the -10-222A/11- on the engine lifting eye.
– Pretension the engine with the spindle, do not lift.
Assembling
Assemble in the reverse order of removal. Note the following:
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
2.3

Engine Mount, Removing and Installing

⇒ "2.3.1 Engine Mount, Removing and Installing", page 38
⇒ "2.3.2 Support Bearing, Removing and Installing", page 40
2.3.1 Engine Mount, Removing and Installing
Removing
– Remove the front noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Remove the front wheel spoiler. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Wheel Housing Liner; Overview - Front Wheel
Housing Liner .
38
Rep. Gr.10 - Engine Assembly
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.