Audi A4 2015 Repair Manual page 71

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Remove the connectors -2 and 3- from the bracket and dis‐
connect.
– Disconnect the connectors -4 and 5-.
– Remove the bolts -1- from the bracket.
– Disconnect the connector -3-.
– Version with MPI system: disconnect the connectors
-1 and 2-.
All additional procedures are described under: ⇒ Servicing – 4-
Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 15 ; Cylinder Head;
Cylinder Head, Removing and Installing .
Tightening Specifications
♦ Refer ⇒ "1.1 Overview - Muffler", page 169
♦ Bracket for wiring harness. Refer to ⇒ Wiring diagrams, Trou‐
bleshooting & Component locations.
3.2.2 Cylinder Head, Removing and Installing,
Vehicles with Particulate Filter
♦ Gasket - Cylinder Head to Engine
♦ Gasket - Turbocharger to Engine
♦ Gasket - Catalytic Converter to Cylinder Head
♦ Bolt - Cylinder Head to Engine
♦ O-ring - Connection for Coolant Hose to Cylinder Head
♦ O-ring - Oil Supply Line
♦ Bolt - Engine Lifting Eye to Cylinder Head
♦ Bolts - Turbocharger to Engine
♦ Nuts - Catalytic Converter to Cylinder Head
Removing
– Remove the camshafts. Refer to
⇒ "4.2 Camshaft, Removing and Installing", page 69
CAUTION
Risk of Destroying the Engine by Adjusting the Valve Timing
– Do not turn the crankshaft after removing the camshafts.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
65
3. Cylinder Head