Audi A4 2015 Repair Manual page 181

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Loosen the clamping sleeve -arrows- and push toward the
rear.
CAUTION
Risk of Damaging the Coupling Due to Improper Handling
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Remove the front muffler.
Installing
Install in reverse order of removal and note the following:
• Replace seal after disassembly.
– Install the exhaust system without tension. Refer to
⇒ "1.5 Exhaust System, Installing without Tension",
page 177 .
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Tightening Specifications
♦ Refer to ⇒ "1.1 Overview - Muffler", page 169
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
1.3.2 Front Muffler, Removing and Installing,
Vehicle with Particulate Filter
Removing
– Remove the nuts -arrows- from the front muffler.
– Remove the front muffler bolts -arrows-. (Shown on the right)
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
175
1. Exhaust Pipes/Mufflers