Table of Contents
Advertisement
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Remove the connector -2- for the Exhaust Gas Temperature
Sensor 3 - G495- from the bracket and disconnect.
– Open the clip -3- and free up the vacuum hose.
– Remove the bolt -1-, and push aside the bracket. There are
different versions.
All additional procedures described. Refer to ⇒ Servicing – 4-
Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 24 ; High Pressure
Pump; High Pressure Pump, Removing and Installing .
Installing
Additional procedures:
– Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Tightening Specifications
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Refer to
⇒ Fig. ""Heat Shield - Tightening Specification"" , page 62
♦ Refer to
⇒ Fig. ""Heat Shield Bracket - Tightening Specification"" , page
62
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
163
6. High Pressure Pump
Hide quick links:
Advertisement
Table of Contents
