Audi A4 2015 Repair Manual page 189

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Free up the wires on the heat shield -1-.
– Remove the nuts -arrows- and bolts -2- and remove the heat
shield. (Shown with the particulate filter removed).
– Remove the connector -2- for the Exhaust Gas Temperature
Sensor 3 - G495- from the bracket and disconnect.
– Open the clip -3- and free up the vacuum hose.
– Remove the bolt -1- and the bracket. There are different ver‐
sions.
– Remove the particulate filter.
Installing
Installation in reverse order of removal and note the following:
– Install the steering intermediate shaft. Refer to ⇒ Suspension,
Wheels Steering; Rep. Gr. 48 ; Steering Column; Steering
Intermediate Shaft, Removing and Installing .
– Install the plenum chamber bulkhead. Refer to ⇒ Body Exte‐
rior; Rep. Gr. 50 ; Bulkhead; Plenum Chamber Bulkhead,
Removing and Installing .
– Install the front muffler. Refer to
⇒ "1.3.2 Front Muffler, Removing and Installing, Vehicle with
Particulate Filter", page 175
After replacing the particulate filter, adaptations need to be made.
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 00 ; Repair Information ; perform adaptations after re‐
placing components.
Tightening Specifications
♦ Refer to
⇒ Fig. ""Heat Shield - Tightening Specification"" , page 62
♦ Refer to
⇒ Fig. ""Heat Shield Bracket - Tightening Specification"" , page
62
♦ Refer to ⇒ Servicing - 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 26 ; Emissions Control System; Overview - Emis‐
sions Control System .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2. Emissions Control System
183