Particulate Filter, Removing And Installing - Audi A4 2015 Repair Manual

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Remove the connector -2- for the Oxygen Sensor 1 After Cat‐
alytic Converter - GX7- -1- from the bracket and disconnect it.
– Remove the nuts -1 and 2- and remove the catalytic converter
toward the rear and upward.
Installing
Install in reverse order of removal and note the following:
• Replace gaskets and self-locking nuts after disassembly.
– Install the air filter housing. Refer to
⇒ "2.2 Air Filter Housing, Removing and Installing",
page 150 .
– Install the particulate filter. Refer to
⇒ "2.3 Particulate Filter, Removing and Installing",
page 181 .
Tightening Specifications
♦ Refer to ⇒ Servicing - 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 26 ; Emissions Control System; Overview - Emis‐
sions Control System .
2.3 Particulate Filter, Removing and Instal‐
ling
Removing
– Remove the front muffler. Refer to
⇒ "1.3.2 Front Muffler, Removing and Installing, Vehicle with
Particulate Filter", page 175
– Remove the plenum chamber bulkhead. Refer to ⇒ Body Ex‐
terior; Rep. Gr. 50 ; Bulkhead; Plenum Chamber Bulkhead,
Removing and Installing .
– Remove the steering intermediate shaft from the steering gear
and push together. Refer to ⇒ Suspension, Wheels, Steering;
Rep. Gr. 48 ; Steering Column; Steering Intermediate Shaft,
Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
2. Emissions Control System
181