Coolant Pipes; Overview - Coolant Pipes - Audi A4 2015 Repair Manual

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
3

Coolant Pipes

⇒ "3.1 Overview - Coolant Pipes", page 111
⇒ "3.2 Coolant Pipes, Removing and Installing", page 112
⇒ "3.3 Transmission Coolant Pipes, Removing and Installing",
page 116
3.1

Overview - Coolant Pipes

♦ Overview - Coolant Pipes on Engine. Refer to
♦ Overview - Transmission Coolant Pipes. Refer to
⇒ page 112 .
Arrows on coolant pipes and coolant hoses must align.
Overview - Coolant Pipes on Engine
1 - Bolt
❑ 9 Nm
2 - Coolant Hose
3 - Left Coolant Pipe
❑ Removing and instal‐
ling. Refer to
⇒ "3.2.1 Left Coolant
Pipe, Removing and In‐
stalling", page 112
4 - Coolant Hose
5 - Bolt
❑ 20 Nm
6 - Bolt
❑ 9 Nm
7 - Bolt
❑ 20 Nm
8 - Right Coolant Pipe
❑ Removing and instal‐
ling. Refer to
⇒ "3.2.2 Right Coolant
Pipe, Removing and In‐
stalling, Vehicles with‐
out Particulate Filter",
page 113 .
9 - O-Ring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
❑ Always replace after re‐
with respect to the correctness of information in this document. Copyright by AUDI AG.
moving.
10 - Coolant Hose
❑ Fold back and pry up the
clip to remove the heat
shield boot
❑ Connecting. Refer to
11 - O-Ring
❑ Always replace after removing.
12 - Bolt
❑ 6 Nm
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
.
⇒ Fig. ""Connect the Coolant Hose to the Connector Coupling"" , page 119
⇒ page 111 .
.
111
3. Coolant Pipes