Fan Shroud, Removing And Installing - Audi A4 2015 Repair Manual

Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4.3

Fan Shroud, Removing and Installing

Removing
– Remove the front noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Noise Insulation, Removing
and Installing .
– Remove the charge air cooler. Refer to
⇒ "2.3 Charge Air Cooler, Removing and Installing",
page 134 .
WARNING
There is a risk of injury if the radiator fan turns on by itself.
– When performing procedures near the radiator maintain a
distance to the radiator.
– Disconnect the radiator fan connector -arrow-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Unclip the lower air duct -arrow-.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the left and right bolt -2- for the radiator bracket -1-.
124
Rep. Gr.19 - Cooling System