Audi A4 2015 Repair Manual page 33

4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
– Disconnect the connector -1- for the Oxygen Sensor 1 Before
Catalytic Converter - GX10- -2-. (There are different installa‐
tion positions.)
– Free up the wiring harness on the engine and move to the side.
– Remove the nuts -1- and the catalytic converter toward the
rear upward.
– Disconnect the fuel hose -1-. Refer to ⇒ Fuel Supply System;
Rep. Gr. 20 ; Connector Couplings; Connector Couplings,
Disconnecting .
– Loosen the hose clamps to disconnect the hose for the EVAP
system -2-.
– Lift the clamp -arrow- and remove the coolant hose.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
1. Engine, Removing and Installing
27