Device Warnings; Computer Connection; Starting The Demo Mode - Innomed Medical HS112 C-1 User Manual

12-channel ecg device with 112 mm wide built-in printer, colour touch screen lcd display
Table of Contents

Advertisement

14. Device warnings

The possible warnings and recommended actions are listed below.
Memory OK
Memory error
Not enough memory
The heart frequency
is too high
There is no stored
record yet
The printer is
overheated
Printer error
The battery is
depleted
Check the electrodes
The ECG is too
noisy
There are few
recognizable beats

15. Computer connection

The Innobase for Windows cardiological database management program can be purchased
for the HS112 C-1 device. The program manages the patient database, stored records, it
performs 12-channel monitoring, record display and evaluation, and it can print in an A4
format. Using the Innobase program is described in a separate manual.
The device can be connected to a computer via a USB cable. The required minimal PC
configuration could be find in the Innobase user manual.

16. Starting the demo mode

The device has a pre-programmed demo mode that can be used when the device is being
exhibited, or for presentational purposes. In order to run the demo mode, touch the screen
with 3 fingers immediately after turning the device on (at most 3 seconds after an image is
displayed on the screen). Exiting the demo mode can be done by restarting the device.
R-6730-EN02-E
HS112 C-1 User Manual
No action required.
Due to an error, the stored data was damaged, and
the device has reset to factory settings. No action
required.
Occurring with the Diagnosis or Store function; an
older record has to be deleted.
A diagnosis can be obtained only under a 175 BPM
frequency.
Appearing on entering the catalogue in case there are
no stored records.
Printing can start in approximately 10 minutes.
Make sure that the paper in the tray is loaded
properly, and that the tray is closed.
The battery has to be charged, or the device has to be
operated by connecting it to the mains power supply.
Appearing when the device detects an electrode
attachment error while printing or starting a
program. Check the leads in the 12-channel mode.
Check the electrodes, turn the filters on.
Appearing during diagnosis creation if the number of
beats is too low.
57/73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Heartscreen112 clinic

Table of Contents